Biblio

In this paper, we use selective laser melting (SLM) technology to fabricate AlNiCo magnetic materials, and the effects of laser processing parameters on the density and mechanical properties of AlNiCo magnetic materials were studied. We tested the magnetic properties of the heat-treated magnets. The results show that both laser power and scanning speed affect the forming. In this paper, the influence of laser power on the density of samples far exceeds the scanning speed. Through the experiment, we obtained the optimal range of process parameters: laser power (150 170W) and laser scanning speed (800 1000mm/s). Although the samples formed within this range have higher density, there are still many cracks, further research work should be done.

This paper reports electroplated CoPt permanent magnets samples yielding thicknesses up to 100 μm, deposition rates up to 35 μm/h, coercivities up to 1000 kA/m (1.25 T), remanences up to 0.8 T, and energy products up to 77 kJ/m3. The impact of electroplating bath temperature and glycine additives are systematically studied. Compared to prior work, these microfabricated magnets not only exhibit up to 10X increase in thickness without sacrificing magnetic performance, but also improve the areal magnetic energy density by 2X. Using a thick removeable SU-8 mold, these high-performing thick-film magnets are intended for magnetic microactuators, magnetic field sensors, energy conversion devices, and more.

This paper proposes a novel kind of direct-current and alternate-decay-current hybrid integrative magnetization and demagnetization power supplies applied to transformer dc bias treatment based on a nanocomposite magnetic material. First, according to the single-phase transformer structure, one dc bias magnetic compensation mechanism was provided. The dc bias flux in the transformer main core could be eliminated directionally by utilizing the material remanence. Second, for the rapid response characteristic of the magnetic material to an external magnetic field, one positive and negative dc magnetization superimposed decaying ac demagnetization hybrid integrative power supplies based on single-phase rectifier circuit and inverter circuit was designed. In order to accurately control the magnetic field strength by which a good de/-magnetization effect could be achieved, this paper adopts the double-loop control technology of the magnetic field strength and magnetizing current for the nanocomposite magnetic state adjustment. Finally, two 10 kVA transformers and the experiment module of the hybrid integrative power supplies were manufactured and built. Experimental results showed that the integrated power supplies have good de/-magnetization effect and practicability, proving the validity and feasibility of the proposed scheme.

The MgO-based magnetic tunnel junction (MTJ) is the basis of modern hard disk drives' magnetic read sensors. Within its operating bandwidth, the sensor's performance is significantly affected by nonlinear and oscillating behavior arising from the MTJ's magnetization dynamics at microwave frequencies. Static I-V curve measurements are commonly used to characterize sensor's nonlinear effects. Unfortunately, these do not sufficiently capture the MTJ's magnetization dynamics. In this paper, we demonstrate the use of the two-tone measurement technique for full treatment of the sensor's nonlinear effects in conjunction with dynamic ones. This approach is new in the field of magnetism and magnetic materials, and it has its challenges due to the nature of the device. Nevertheless, the experimental results demonstrate how the two-tone measurement technique can be used to characterize magnetic sensor nonlinear properties.

This paper design three distribution devices for the strong and smart grid, respectively are novel transformer with function of dc bias restraining, energy-saving contactor and controllable reactor with adjustable intrinsic magnetic state based on nanocomposite magnetic material core. The magnetic performance of this material was analyzed and the relationship between the remanence and coercivity was determined. The magnetization and demagnetization circuit for the nanocomposite core has been designed based on three-phase rectification circuit combined with a capacitor charging circuit. The remanence of the nanocomposite core can neutralize the dc bias flux occurred in transformer main core, can pull in the movable core of the contactor instead of the traditional fixed core and adjust the saturation degree of the reactor core. The electromagnetic design of the three distribution devices was conducted and the simulation, experiment results verify correctness of the design which provides intelligent and energy-saving power equipment for the smart power grids safe operation.