Biblio

The security of logic locking has been called into question by various attacks, especially a Boolean satisfiability (SAT) based attack, that exploits scan access in a working chip. Among other techniques, a robust design-for-security (DFS) architecture was presented to restrict any unauthorized scan access, thereby, thwarting the SAT attack (or any other attack that relies on scan access). Nevertheless, in this work, we successfully break this technique by recovering the secret key despite the lack of scan access. Our security analysis on a few benchmark circuits protected by the robust DFS architecture demonstrates the effectiveness of our attack; on average 95% of the key bits are correctly recovered, and almost 100% in most cases. To overcome this and other prevailing attacks, we propose a defense by making fundamental changes to the robust DFS technique; the new defense can withstand all logic locking attacks. We observe, on average, lower area overhead ( 1.65%) than the robust DFS design ( 5.15%), and similar test coverage ( 99.88%).

Interconnect opens are known to be one of the predominant defects in nanoscale technologies. Automatic test pattern generation for open faults is challenging, because of their rather unstable behavior and the numerous electrical parameters which need to be considered. Thus, most approaches try to avoid accurate modeling of all constraints like the influence of the aggressors on the open net and use simplified fault models in order to detect as many faults as possible or make assumptions which decrease both complexity and accuracy. Yet, this leads to the problem that not only generated tests may be invalidated but also the localization of a specific fault may fail - in case such a model is used as basis for diagnosis. Furthermore, most of the models do not consider the problem of oscillating behavior, caused by feedback introduced by coupling capacitances, which occurs in almost all designs. In [1], the Robust Enhanced Aggressor Victim Model (REAV) and in [2] an extension to address the problem of oscillating behavior were introduced. The resulting model does not only consider the influence of all aggressors accurately but also guarantees robustness against oscillating behavior as well as process variations affecting the thresholds of gates driven by an open interconnect. In this work we present the first diagnostic classification algorithm for this model. This algorithm considers all constraints enforced by the REAV model accurately - and hence handles unknown values as well as oscillating behavior. In addition, it allows to distinguish faults at the same interconnect and thus reducing the area that has to be considered for physical failure analysis. Experimental results show the high efficiency of the new method handling circuits with up to 500,000 non-equivalent faults and considerably increasing the diagnostic resolution.