Biblio

Aiming at the fact that the existing feature quantities cannot well identify the magnetizing inrush current during remanence and bias and the huge number of feature quantities, a new identification method using empirical mode decomposition energy index and artificial intelligence algorithm is proposed in 'this paper. Decomposition and denoising are realized through empirical mode decomposition, and then the corresponding energy index is obtained for the waveform of each inherent modal component and simplified by the mean impact value method. Finally, the accuracy of prediction using artificial intelligence algorithm is close to 100%. This reflects the practicality of the method proposed in 'this article.

In order to improve the reliability of power supply in adjacent hydropower stations, the auxiliary power systems of the two stations are connected through a contact transformer. The magnetizing inrush current generated by the connecting transformer of a hydropower station has the characteristics of high frequency, strong energy, and multi-coupling. The harm caused by the connecting transformer is huge. In order to prevent misoperation during the closing process of the connecting transformer, this article aims at the problem of setting the switching current of the connecting transformer of the two hydropower stations, and establishes the analysis model of the excitation inrush current with SimPowerSystem software, and carries out the quantitative simulation calculation of the excitation inrush current of the connecting transformer. A setting strategy for overcurrent protection of tie transformers to suppress the excitation inrush current is proposed. Under the conditions of changing switch closing time, generator load, auxiliary transformer load, tie transformer core remanence, the maximum amplitude of the excitation inrush current is comprehensively judged Value, and then achieve the suppression of the excitation inrush current, and accurately determine the protection setting of the switch.

In this paper, a transformer model has been developed. The model is based on the equivalent electrical circuit used in transient simulation studies which considers the non-linearity of the iron core. The non-linear ferromagnetic behavior of the iron core was obtained by using the Jiles-Atherton hysteresis model. The magnetizing inrush current of a core type single-phase transformer was analyzed under four different energization conditions. The primary winding of the transformer was connected to the supply at various instants while there was either some level of remanent flux or no remanent flux in the iron core. Corresponding simulation results are presented and discussed.