Biblio

Supply chain cyberattacks that exploit insecure third-party software are a growing concern for the security of the electric power grid. These attacks seek to deploy malicious software in grid control devices during the fabrication, shipment, installation, and maintenance stages, or as part of routine software updates. Malicious software on grid control devices may inject bad data or execute bad commands, which can cause blackouts and damage power equipment. This paper describes an experimental setup to simulate the software update process of a commercial power relay as part of a hardware-in-the-loop simulation for grid supply chain cyber-security assessment. The laboratory setup was successfully utilized to study three supply chain cyber-security use cases.

This paper proposes new concepts for detecting and mitigating cyber attacks on substation automation systems by domain-based cyber-physical security solutions. The proposed methods form the basis of a distributed security domain layer that enables protection devices to collaboratively defend against cyber attacks at substations. The methods utilize protection coordination principles to cross check protection setting changes and can run real-time power system analysis to evaluate the impact of the control commands. The transient fault signature (TFS)-based cross-correlation coefficient algorithm has been proposed to detect the false sampled values data injection attack. The proposed functions were verified in a hardware-in-the-loop (HIL) simulation using commercial relays and a real-time digital simulator (RTDS). Various types of cyber intrusions are tested using this test bed to evaluate the consequences and impacts of cyber attacks to power grid as well as to validate the performance of the proposed research-grade cyber attack mitigation functions.

We develop a novel model-based hardware-in-the-loop (HIL) framework for optimising energy consumption of embedded software controllers. Controller and plant models are specified as networks of parameterised timed input/output automata and translated into executable code. The controller is encoded into the target embedded hardware, which is connected to a power monitor and interacts with the simulation of the plant model. The framework then generates a power consumption model that maps controller transitions to distributions over power measurements, and is used to optimise the timing parameters of the controller, without compromising a given safety requirement. The novelty of our approach is that we measure the real power consumption of the controller and use thus obtained data for energy optimisation. We employ timed Petri nets as an intermediate representation of the executable specification, which facilitates efficient code generation and fast simulations. Our framework uniquely combines the advantages of rigorous specifications with accurate power measurements and methods for online model estimation, thus enabling automated design of correct and energy-efficient controllers.