Biblio

In this paper, physical layer security (PLS) analysis of a cooperative wireless communication system in which the source and destination nodes communicate via a relay employing decode-and-forward protocol is performed for double Rayleigh fading channel model. For the system where the source, relay and target have single antenna, an eavesdropper with multiantenna listens the source and relay together by using maximum-ratio-combining, secrecy outage and positive secrecy capacity possibilities are obtained in closed-form. The theoretical results are verified by Monte-Carlo simulations. From the results, it is observed that as the number of antennas of the eavesdropper is increased, the PLS performance of the system worsens.

Existing methods for home security monitoring depend on expensive custom battery-powered solutions. In this article, we present a battery-free solution that leverages any off-the-shelf passive radio frequency identification (RFID) tag for real-time entry detection. Sensor consists of a printed RFID antenna on paper, coupled to a magnetic reed switch and is affixed on the door. Opening of the door triggers the reed switch causing RFID signal transmission detected by any off-the-shelf passive RFID reader. This paper shows simulation and experimental results for such magnetically-actuated RFID (or magRFID) opening sensor.

Wireless technology is growing at a fast rate to accommodate the expanding user demands. Currently the radio frequency (RF) spectrum is highly congested and more susceptible to signal fratricide and interference. Therefore, full duplexing techniques are required to enhance the access to the spectrum. Simultaneous Transmit and receive systems (STAR), also known as in-band full duplex systems, are gaining higher attention due to their capability to double spectral efficiency. However, successful implementation of STAR systems requires significant isolation between the transmit and receive signals to reduce self-interference (SI) signal. To minimize this self-interference, front-end coupling cancellation circuits are employed in STAR system. In this paper, an RF coupling suppression circuit is presented based on a hybrid finite impulse response filter (FIR) and resonator architecture. Notably, this newly developed FIR-resonator circuit achieves \textbackslashtextgreater30dB cancellation across a \textbackslashtextgreater1.5:1 bandwidth.

This paper presents a proximity coupled wideband wearable antenna operating between 4.71 GHz and 5.81 GHz with 5.2 GHz as centre frequency for biomedical telemetry applications in ISM band (IEEE 802.11 Standard). Two layers of different flexible substrate materials, ethylene-vinyl acetate and felt make the design mechanically stable. Bandwidth improvement is achieved by introducing two slots on elliptical ground plane. Highest gain of 3.72 dB and front to back ratio (FBR) of 6.55 is obtained in the given frequency band. The dimensions of antenna have been optimized to have desired bandwidth of 1100 MHz (\$\textbackslashtextbackslashsimeq\$21%). The specific absorption rate (SAR) value is 1.12 \$W/Kg\$ for 1 g of human body tissue. Both simulated and measured results are presented for the structure.

This article presents a practical approach for secure key exchange exploiting reciprocity in wireless transmission. The method relies on the reciprocal channel phase to mask points of a Phase Shift Keying (PSK) constellation. Masking is achieved by adding (modulo 2π) the measured reciprocal channel phase to the PSK constellation points carrying some of the key bits. As the channel phase is uniformly distributed in [0, 2π], knowing the sum of the two phases does not disclose any information about any of its two components. To enlarge the key size over a static or slow fading channel, the Radio Frequency (RF) propagation path is perturbed to create independent realizations of multi-path fading. Prior techniques have relied on quantizing the reciprocal channel state measured at the two ends and thereby suffer from information leakage in the process of key consolidation (ensuring the two ends have access to the same key). The proposed method does not suffer from such shortcomings as raw key bits can be equipped with Forward Error Correction (FEC) without affecting the masking (zero information leakage) property. To eavesdrop a phase value shared in this manner, the Eavesdropper (Eve) would require to solve a system of linear equations defined over angles, each equation corresponding to a possible measurement by the Eve. Channel perturbation is performed such that each new channel state creates an independent channel realization for the legitimate nodes, as well as for each of Eves antennas. As a result, regardless of the Eves Signal-to-Noise Ratio (SNR) and number of antennas, Eve will always face an under-determined system of equations. On the other hand, trying to solve any such under-determined system of linear equations in terms of an unknown phase will not reveal any useful information about the actual answer, meaning that the distribution of the answer remains uniform in [0, 2π].

In the context of emerging applications such as IoT, an RFID framework that can dynamically incorporate, identify, and seamlessly regulate the RFID tags is considered exciting. Earlier RFID frameworks developed using the older web technologies were limited in their ability to provide complete information about the RFID tags and their respective locations. However, the new and emerging web technologies have transformed this scenario and now framework can be developed to include all the required flexibility and security for seamless applications such as monitoring of RFID tags. This paper revisits and proposes a generic scenario of an RFID framework built using latest web technology and demonstrates its ability to customize using an application for tracking of personal user objects. This has been shown that the framework based on newer web technologies can be indeed robust, uniform, unified, and integrated.

In this paper, we propose a novel pseudo-random beamforming technique with beam selection for improving physical-layer security (PLS) in a downlink cellular network where consists of a base station (BS) with Ntantennas, NMSlegitimate mobile stations (MSs), and NEeavesdroppers. In the proposed technique, the BS generates multiple candidates of beamforming matrix each of which consists of orthogonal beamforming vectors in a pseudo-random manner. Each legitimate MS opportunistically feeds back the received signal-to-interference-and-noise ratio (SINR) value for all beamforming vectors to the BS. The BS transmits data to the legitimate MSs with the optimal beamforming matrix among multiple beam forming matrices that maximizes the secrecy sum-rate. Simulation results show that the proposed technique outperforms the conventional random beamforming technique in terms of the achievable secrecy sum-rate.

For location-aware applications in wireless sensor networks (WSNs), it is important to ensure that sensor nodes can get correct locations in a hostile WSNs. Sybil attacks, which are vital threats in WSNs, especially in the distributed WSNs. They can forge one or multiple identities to decrease the localization accuracy, or sometimes to collapse the whole localization systems. In this paper, a novel lightweight sybilfree (SF)-APIT algorithm is presented to solve the problem of sybil attacks in APIT localization scheme, which is a popular range-free method and performs at individual node in a purely distributed fashion. The proposed SF-APIT scheme requires minimal overhead for wireless devices and works well based on the received signal strength. Simulations demonstrate that SF-APIT is an effective scheme in detecting and defending against sybil attacks with a high detection rate in distributed wireless localization schemes.

This paper considers a pilot spoofing attack scenario in a massive MIMO system. A malicious user tries to disturb the channel estimation process by sending interference symbols to the base-station (BS) via the uplink. Another legitimate user counters by sending random symbols. The BS does not possess any partial channel state information (CSI) and distribution of symbols sent by malicious user a priori. For such scenario, this paper aims to separate the channel directions from the legitimate and malicious users to the BS, respectively. A blind channel separation algorithm based on estimating the characteristic function of the distribution of the signal space vector is proposed. Simulation results show that the proposed algorithm provides good channel separation performance in a typical massive MIMO system.

With the advancement of unmanned aerial vehicles (UAV), 3D wireless mesh networks will play a crucial role in next generation mission critical wireless networks. Along with providing coverage over difficult terrain, it provides better spectral utilization through 3D spatial reuse. However, being a wireless network, 3D meshes are vulnerable to jamming/disruptive attacks. A jammer can disrupt the communication, as well as control of the network by intelligently causing interference to a set of nodes. This paper presents a distributed mechanism of avoiding jamming attacks by means of 3D spatial filtering where adaptive beam nulling is used to keep the jammer in null region in order to bypass jamming. Kalman filter based tracking mechanism is used to estimate the most likely trajectory of the jammer from noisy observation of the jammer's position. A beam null border is determined by calculating confidence region of jammer's current and next position estimates. An optimization goal is presented to calculate optimal beam null that minimizes the number of deactivated links while maximizing the higher value of confidence for keeping the jammer inside the null. The survivability of a 3D mesh network with a mobile jammer is studied through simulation that validates an 96.65% reduction in the number of jammed nodes.

We address secure resource allocation for an OFDMA cooperative cognitive radio network (CRN) with energy harvesting (EH) capability. In the network, one primary user (PU) cooperates with several untrusted secondary users (SUs) with one SU transmitter and several SU receivers, where the SU transmitter and all SU receivers may overhear the PU transmitter's information while all SU receivers may eavesdrop on each other's signals. We consider the scenario when SUs are wireless devices with small physical sizes; therefore to improve system performance we suppose that SUs are equipped with co-located orthogonally dual-polarized antennas (ODPAs). With ODPAs, on one hand, the SU transmitter can first harvest energy from radio frequency (RF) signals emitted by the PU transmitter, and then utilize the harvested energy to simultaneously serve the PU and all SU receivers. On the other hand, by exploiting polarization-based signal processing techniques, both the PU's and SUs' physical-layer security can be enhanced. In particular, to ensure the PU's communication security, the PU receiver also sends jamming signals to degrade the reception performance of SUs, and meanwhile the jamming signals can also become new sources of energy powering the SU transmitter. For the considered scenario, we investigate the joint allocation of subcarriers, powers, and power splitting ratios to maximize the total secrecy rate of all SUs while ensuring the PU's minimum secrecy rate requirement. Finally, we evaluate the performance of our resource allocation scheme through numerical analyses.

This paper presents an entirely new RFID tag antenna design that incorporates the QR (Quick Response) code for security purposes. The tag antenna is designed to work at 2.45 GHz frequency. The RFID integrated QR code tag antenna is printed with an additive material deposition system that enables to produce a low cost tag antenna with extended security.

We present a new method for mitigating wall return and a new greedy algorithm for detecting stationary targets after wall clutter has been cancelled. Given limited measurements of a stepped-frequency radar signal consisting of both wall and target return, our objective is to detect and localize the potential targets. Modulated Discrete Prolate Spheroidal Sequences (DPSS's) form an efficient basis for sampled bandpass signals. We mitigate the wall clutter efficiently within the compressive measurements through the use of a bandpass modulated DPSS basis. Then, in each step of an iterative algorithm for detecting the target positions, we use a modulated DPSS basis to cancel nearly all of the target return corresponding to previously selected targets. With this basis, we improve upon the target detection sensitivity of a Fourier-based technique.

Joint transmission coordinated multi-point (CoMP) is a combination of constructive and destructive superposition of several to potentially many signal components, with the goal to maximize the desired receive-signal and at the same time to minimize mutual interference. Especially the destructive superposition requires accurate alignment of phases and amplitudes. Therefore, a 5G clean slate approach needs to incorporate the following enablers to overcome the challenging limitation for JT CoMP: accurate channel estimation of all relevant channel components, channel prediction for time-aligned precoder design, proper setup of cooperation areas corresponding to user grouping and to limit feedback overhead especially in FDD as well as treatment of out-of-cluster interference (interference floor shaping).

In this paper, we investigate the performance of multiple-input multiple-output aided coded interleave division multiple access (IDMA) system for secured medical image transmission through wireless communication. We realize the MIMO profile using four transmit antennas at the base station and three receive antennas at the mobile station. We achieve bandwidth efficiency using discrete wavelet transform (DWT). Further we implement Arnold's Cat Map (ACM) encryption algorithm for secured medical transmission. We consider celulas as medical image which is used to differentiate between normal cell and carcinogenic cell. In order to accommodate more users' image, we consider IDMA as accessing scheme. At the mobile station (MS), we employ non-linear minimum mean square error (MMSE) detection algorithm to alleviate the effects of unwanted multiple users image information and multi-stream interference (MSI) in the context of downlink transmission. In particular, we investigate the effects of three types of delay-spread distributions pertaining to Stanford university interim (SUI) channel models for encrypted image transmission of MIMO-IDMA system. From our computer simulation, we reveal that DWT based coded MIMO- IDMA system with ACM provides superior picture quality in the context of DL communication while offering higher spectral efficiency and security.

Radio Frequency IDentification (RFID) is a technique for speedy and proficient identification system, it has been around for more than 50 years and was initially developed for improving warfare machinery. RFID technology bridges two technologies in the area of Information and Communication Technologies (ICT), namely Product Code (PC) technology and Wireless technology. This broad-based rapidly expanding technology impacts business, environment and society. The operating principle of an RFID system is as follows. The reader starts a communication process by radiating an electromagnetic wave. This wave will be intercepted by the antenna of the RFID tag, placed on the item to be identified. An induced current will be created at the tag and will activate the integrated circuit, enabling it to send back a wave to the reader. The reader redirects information to the host where it will be processed. RFID is used for wide range of applications in almost every field (Health, education, industry, security, management ...). In this review paper, we will focus on agricultural and environmental applications.

We consider the block Rayleigh fading multiple-input multiple-output (MIMO) wiretap channel with no prior channel state information (CSI) available at any of the terminals. The channel gains remain constant in a coherence time of T symbols, and then change to another independent realization. The transmitter, the legitimate receiver and the eavesdropper have nt, nr and ne antennas, respectively. We determine the exact secure degrees of freedom (s.d.o.f.) of this system when T ≥ 2 min(nt, nr). We show that, in this case, the s.d.o.f. is exactly (min(nt, nr) - ne)+(T - min(nt, nr))/T. The first term can be interpreted as the eavesdropper with ne antennas taking away ne antennas from both the transmitter and the legitimate receiver. The second term can be interpreted as a fraction of s.d.o.f. being lost due to the lack of CSI at the legitimate receiver. In particular, the fraction loss, min(nt, nr)/T, can be interpreted as the fraction of channel uses dedicated to training the legitimate receiver for it to learn its own CSI. We prove that this s.d.o.f. can be achieved by employing a constant norm channel input, which can be viewed as a generalization of discrete signalling to multiple dimensions.