Biblio

Due to the network topology high dynamic changes, the number of ground users and the impact of uneven traffic, the load difference between SDN-based satellite network controllers varies widely, which will cause network performance such as network delay and throughput to drop dramatically. Aiming at the above problems, a multi-controller optimized deployment strategy of satellite network based on SDN was proposed. First, the controller's load state is divided into four types: overload state, high load state, normal state, and idle state; second, when a controller in the network is idle, the switch under its jurisdiction is migrated to the adjacent low load controller and turn off the controller to reduce waste of resources. When the controller is in a high-load state and an overload state, consider both the controller and the switch, and migrate the high-load switch to the adjacent low-load controller. Balance the load between controllers, improve network performance, and improve network performance and network security. Simulation results show that the method has an average throughput improvement of 2.7% and a delay reduction of 3.1% compared with MCDALB and SDCLB methods.

In wireless sensor networks (WSNs), congestion control is a very essential region of concern. When the packets that are coming get increased than the actual capacity of network or nodes results into congestion in the network. Congestion in network can cause reduction in throughput, increase in network delay, and increase in packet loss and sensor energy waste. For that reason, new complex methods are mandatory to tackle with congestion. So it is necessary to become aware of congestion and manage the congested resources in wireless sensor networks for enhancing the network performance. Diverse methodologies for congestion recognition and prevention have been presented in the previous couple of years. To handle some of the problems, this paper exhibits a new technique for controlling the congestion. An efficient and reliable routing protocol (ERRP) based on bio inspired algorithms is introduced in this paper for solving congestion problem. In the proposed work, a way is calculated to send the packets on the new pathway. The proposed work has used three approaches for finding the path which results into a congestion free path. Our analysis and simulation results shows that our approach provides better performance as compared to previous approaches in terms of throughput, packet loss, delay etc.

In the field of video surveillance, the demands of intelligent video analysis services based on Deep Neural Networks (DNNs) have grown rapidly. Although most existing studies focus on the performance of DNNs pre-deployed at remote clouds, the network delay caused by computation offloading from network cameras to remote clouds is usually long and sometimes unbearable. Edge computing can enable rich services and applications in close proximity to the network cameras. However, owing to the limited computing resources of distributed edge clouds, it is challenging to satisfy low latency and high accuracy requirements for all users, especially when the number of users surges. To address this challenge, we first formulate the intelligent video surveillance task scheduling problem that minimizes the average response time while meeting the performance requirements of tasks and prove that it is NP-hard. Second, we present an adaptive DNN model selection method to identify the most effective DNN model for each task by comparing the feature similarity between the input video segment and pre-stored training videos. Third, we propose a two-stage delay-aware graph searching approach that presents a beneficial trade-off between network delay and computing delay. Experimental results demonstrate the efficiency of our approach.

Thanks to the occurrence of the Internet of Things (IoT), the devices are able to collect and transmit data via the Internet and contributing to our big data world. It will permit devices to exchange monitoring data content in real time. Real-time communication (RTC) with these devices was analyzed in respect to the Network delay. Network coding (NC) combines data packets and the output packet which is a mixture of the input packets. This technique can provide many potential gains to the network, including reducing Round-Trip Time (RTT), decreasing latency and improving Network delay (ND). In the present paper, the authors improve network delay metrics in the context of the remote management of renewable energy using a random NC with an efficient strategy technique.