Biblio

Artificial neural networks allow the identification of black-box models. This paper proposes a method aimed at replicating the static and dynamic behavior of a DC-DC power converter based on a recurrent nonlinear autoregressive exogenous neural network. The method proposed in this work applies an algorithm that trains a neural network based on the inputs and outputs (currents and voltages) of a Buck converter. The approach is validated by means of simulated data of a realistic nonsynchronous Buck converter model programmed in Simulink and by means of experimental results. The predictions made by the neural network are compared to the actual outputs of the system, to determine the accuracy of the method, thus validating the proposed approach. Both simulation and experimental results show the feasibility and accuracy of the proposed black-box approach.

This paper deals with effects of current sensor bandwidth and time delays in a system controlled by a Phase-Shift Self-Oscillating Current Controller (PSSOCC). The robustness of this current controller has been proved in former works showing its good performances in a large range of applications including AC/DC and DC/AC converters, power factor correction, active filters, isolation amplifiers and motor control. As switching frequencies can be upper than 30kHz, time delays and bandwidth limitations cannot be neglected in comparison with former works on this robust current controller. Thus, several models are proposed in this paper to analyze system behaviours. Those models permit to find analytical expressions binding maximum oscillation frequency with time delay and/or additional filter parameters. Through current spectrums analysis, quality of analytical expressions is proved for each model presented in this work. An experimental approach shows that every element of the electronic board having a low-pass effect or delaying command signals need to be included in the model in order to have a perfect match between calculations, simulations and practical results.

Quasi-steady-state (QSS) large-signal models are often taken for granted in the analysis and design of DC-DC switching converters, particularly for varying operating conditions. In this study, the premise for the QSS is justified quantitatively for the first time. Based on the QSS, the DC-DC switching converter under varying operating conditions is reduced to the linear time varying systems model. Thereafter, the QSS concept is applied to analysis of frequency-domain properties of the DC-DC switching converters by using three-dimensional Bode plots, which is then utilised to the optimisation of the controller parameters for wide variations of input voltage and load resistance. An experimental prototype of an average-current-mode-controlled boost DC-DC converter is built to verify the analysis and design by both frequency-domain and time-domain measurements.