Biblio

This paper presents a method optimizing the thrust force of a Micro Electro Mechanical System (MEMS) Permanent Magnet Linear Motor, based on harmonic current injection. Fourier decomposition is implemented to the air gap flux density of the motor to derive the fitting expression of the thrust force dependent to exciting current. Through analyzing the thrust force ripple of sinusoidal current excitement, the paper comes up with the strategy of harmonic current injection to eliminate the ripple component in the thrust force waveform. Mathematical demonstration is given that injecting harmonic current can totally eliminate the ripple caused by odd component of vertical air gap magnetic induction intensity. Simulation verification is implemented based on the 3rd and 7th harmonic injection control strategy, proving that the method is feasible for the thrust ripple is reduced to 4.3% of the value before optimazation. Experimental results lead to the consistent conclusion that the strategy shows good steady-state and dynamic performance.

This paper presents a new class of high-performance permanent micro-magnets based on the controlled assembly of cobalt nanorods for the electromagnetic transduction of MEMS. Micromagnets are fabricated using a low temperature fabrication process that yields a dense material exhibiting high coercive field and remanence to saturation magnetization ratio. The cartography of the magnetic induction produced by the sub-millimeter size magnets was obtained using a scanning Hall effect micro-probe microscope. Silicon microcantilevers placed in the vicinity of these magnets were successfully actuated using the Lorentz force with low currents. The good signal to noise ratio measured at resonance demonstrates the potentiality of these nanostructured micro-magnets.

{This paper describes application of permanent magnet on permanent magnet generator (PMG) for renewable energy power plants. Permanent magnet used are bonded hybrid magnet that was a mixture of barium ferrite magnetic powders 50 wt % and NdFeB magnetic powders 50 wt % with 15 wt % of adhesive polymer as a binder. Preparation of bonded hybrid magnets by hot press method at a pressure of 2 tons and temperature of 200°C for 15 minutes. The magnetic properties obtained were remanence induction (Br) =1.54 kG, coercivity (Hc) = 1.290 kOe, product energy maximum (BHmax) = 0.28 MGOe, surface remanence induction (Br) = 1200 gauss