Biblio

Scanning Transmission Electron Microscopy (STEM) offers high-resolution images that are used to quantify the nanoscale atomic structure and composition of materials and biological specimens. In many cases, however, the resolution is limited by the electron beam damage, since in traditional STEM, a focused electron beam scans every location of the sample in a raster fashion. In this paper, we propose a scanning method based on the theory of Compressive Sensing (CS) and subsampling the electron probe locations using a line hop sampling scheme that significantly reduces the electron beam damage. We experimentally validate the feasibility of the proposed method by acquiring real CS-STEM data, and recovering images using a Bayesian dictionary learning approach. We support the proposed method by applying a series of masks to fully-sampled STEM data to simulate the expectation of real CS-STEM. Finally, we perform the real data experimental series using a constrained-dose budget to limit the impact of electron dose upon the results, by ensuring that the total electron count remains constant for each image.

Nanosize multiferroic La-doped YFeO3 powders are harvested via a low-temperature solid-state reaction method. X-ray diffraction (XRD), scanning electron microscopy (SEM) and Raman spectra analysis reveal that with La addition, YFeO3 powders are successfully fabricated at a lower temperature with the size below 60 nm, and a refined structure is obtained. Magnetic hysteresis loop illustrates ferromagnetic behavior of YFeO3 nano particles can be enhanced with La addition. The maximum and remnant magnetization of the powders are about 4.03 and 1.22 emu/g, respectively. It is shown that the optical band gap is around 2.25 eV, proving that La doped YFeO3 nano particles can strongly absorb visible light. Both magnetic and optical properties are greatly enhanced with La addition, proving its potential application in magnetic and optical field.

Hardware Trojans are malicious modifications on integrated circuits (IC), which pose a grave threat to the security of modern military and commercial systems. Existing methods of detecting hardware Trojans are plagued by the inability of detecting all Trojans, reliance on golden chip that might not be available, high time cost, and low accuracy. In this paper, we present Golden Gates, a novel detection method designed to achieve a comparable level of accuracy to full reverse engineering, yet paying only a fraction of its cost in time. The proposed method inserts golden gate circuits (GGC) to achieve superlative accuracy in the classification of all existing gate footprints using rapid scanning electron microscopy (SEM) and backside ultra thinning. Possible attacks against GGC as well as malicious modifications on interconnect layers are discussed and addressed with secure built-in exhaustive test infrastructure. Evaluation with real SEM images demonstrate high classification accuracy and resistance to attacks of the proposed technique.

Alternatives to rare earth permanent magnets, such as alnico, will reduce supply instability, increase sustainability, and could decrease the cost of permanent magnets, especially for high-temperature applications, such as traction drive motors. Alnico magnets with moderate coercivity, high remanence, and relatively high-energy product are conventionally processed by directional solidification and (significant) final machining, contributing to increased costs and additional material waste. Additive manufacturing (AM) is developing as a cost effective method to build net-shape 3-D parts with minimal final machining and properties comparable to wrought parts. This paper describes initial studies of net-shape fabrication of alnico magnets by AM using a laser engineered net shaping (LENS) system. High-pressure gas atomized pre-alloyed powders of two different modified alnico “8” compositions, with high purity and sphericity, were built into cylinders using the LENS process, and followed by heat treatment. The magnetic properties showed improvement over their cast and sintered counterparts. The resulting alnico permanent magnets were characterized using scanning electron microscopy, energy dispersive spectroscopy, electron backscatter diffraction, and hysteresisgraph measurements. These results display the potential for net-shape processing of alnico permanent magnets for use in next generation traction-drive motors and other applications requiring high temperatures and/or complex engineered part geometries.