Biblio
Hardware implementations of cryptographic algorithms may leak information through numerous side channels, which can be used to reveal the secret cryptographic keys, and therefore compromise the security of the algorithm. Power Analysis Attacks (PAAs) [1] exploit the information leakage from the device's power consumption (typically measured on the supply and/or ground pins). Digital circuits consume dynamic switching energy when data propagate through the logic in each new calculation (e.g. new clock cycle). The average power dissipation of a design can be expressed by: Ptot(t) = α · (Pd(t) + Ppvt(t)) (1) where α is the activity factor (the probability that the gate will switch) and depends on the probability distribution of the inputs to the combinatorial logic. This induces a linear relationship between the power and the processed data [2]. Pd is the deterministic power dissipated by the switching of the gate, including any parasitic and intrinsic capacitances, and hence can be evaluated prior to manufacturing. Ppvt is the change in expected power consumption due to nondeterministic parameters such as process variations, mismatch, temperature, etc. In this manuscript, we describe the design of logic gates that induce data-independent (constant) α and Pd.
Ensemble waveform analysis is used to calculate signal to noise ratio (SNR) and other recording characteristics from micromagnetically modeled heat assisted magnetic recording waveforms and waveforms measured at both drive and spin-stand level. Using windowing functions provides the breakdown between transition and remanence SNRs. In addition, channel bit density (CBD) can be extracted from the ensemble waveforms using the di-bit extraction method. Trends in both transition SNR, remanence SNR, and CBD as a function of ambient temperature at constant track width showed good agreement between model and measurement. Both model and drive-level measurement show degradation in SNR at higher ambient temperatures, which may be due to changes in the down-track profile at the track edges compared with track center. CBD as a function of cross-track position is also calculated for both modeling and spin-stand measurements. The CBD widening at high cross-track offset, which is observed at both measurement and model, was directly related to the radius of curvature of the written transitions observed in the model and the thermal profiles used.
In this paper, we propose a theoretical framework to investigate the eavesdropping behavior in underwater acoustic sensor networks. In particular, we quantify the eavesdropping activities by the eavesdropping probability. Our derived results show that the eavesdropping probability heavily depends on acoustic signal frequency, underwater acoustic channel characteristics (such as spreading factor and wind speed) and different hydrophones (such as isotropic hydrophones and array hydrophones). Simulation results have further validate the effectiveness and the accuracy of our proposed model.
The display image on the visual display unit (VDU) can be retrieved from the radiated and conducted emission at some distance with no trace. In this paper, the maximum eavesdropping distance for the unintentional radiation and conduction electromagnetic (EM) signals which contain information has been estimated in theory by considering some realistic parameters. Firstly, the maximum eavesdropping distance for the unintentional EM radiation is estimated based on the reception capacity of a log-periodic antenna which connects to a receiver, the experiment data, the attenuation in free-space and the additional attenuation in the propagation path. And then, based on a multi-conductor transmission model and some experiment results, the maximum eavesdropping distance for the conducted emission is theoretically derived. The estimating results demonstrated that the ITE equipment may also exist threat of the information leakage even if it has met the current EMC requirements.
Next generation 5G wireless networks pose several important security challenges. One fundamental challenge is key management between the two communicating parties. The goal is to establish a common secret key through an unsecured wireless medium. In this paper, we introduce a new physical layer paradigm for secure key exchange between the legitimate communication parties in the presence of a passive eavesdropper. The proposed method ensures secrecy via pre-equalization and guarantees reliable communications by the use of Low Density Parity Check (LDPC) codes. One of the main findings of this paper is to demonstrate through simulations that the diversity order of the eavesdropper will be zero unless the main and eavesdropping channels are almost correlated, while the probability of key mismatch between the legitimate transmitter and receiver will be low. Simulation results demonstrate that the proposed approach achieves very low secret key mismatch between the legitimate users, while ensuring very high error probability at the eavesdropper.
Friendly jamming is a physical layer security technique that utilizes extra available nodes to jam any eavesdroppers. This paper considers the use of additional available nodes as friendly jammers in order to improve the security performance of a route through a wireless area network. One of the unresolved technical challenges is the combining of security metrics with typical service quality metrics. In this context, this paper considers the problem of routing through a D2D network while jointly minimizing the secrecy outage probability (SOP) and connection outage probability (COP), using friendly jamming to improve the SOP of each link. The jamming powers are determined to place nulls at friendly receivers while maximizing the power to eavesdroppers. Then the route metrics are derived, and the problem is framed as a convex optimization problem. We also consider that not all network users equally value SOP and COP, and so introduce an auxiliary variable to tune the optimization between the two metrics.
Security threats such as jamming and route manipulation can have significant consequences on the performance of modern wireless networks. To increase the efficacy and stealthiness of such threats, a number of extremely challenging, next-generation cross-layer attacks have been recently unveiled. Although existing research has thoroughly addressed many single-layer attacks, the problem of detecting and mitigating cross-layer attacks still remains unsolved. For this reason, in this paper we propose a novel framework to analyze and address cross-layer attacks in wireless networks. Specifically, our framework consists of a detection and a mitigation component. The attack detection component is based on a Bayesian learning detection scheme that constructs a model of observed evidence to identify stealthy attack activities. The mitigation component comprises a scheme that achieves the desired trade-off between security and performance. We specialize and evaluate the proposed framework by considering a specific cross-layer attack that uses jamming as an auxiliary tool to achieve route manipulation. Simulations and experimental results obtained with a testbed made up by USRP software-defined radios demonstrate the effectiveness of the proposed methodology.
In this paper, we introduce an optical network with cross-layer security, which can enhance security performance. In the transmitter, the user's data is encrypted at first. After that, based on optical encoding, physical layer encryption is implemented. In the receiver, after the corresponding optical decoding process, decryption algorithm is used to restore user's data. In this paper, the security performance has been evaluated quantitatively.
Next generation cellular networks will provide users better experiences by densely deploying smaller cells, which results in more complicated interferences environment. In order to coordinate interference, power control for uplink is particularly challenging due to random locations of uplink transmitter and dense deployment. In this paper, we address the uplink fractional power control (FPC) optimization problem from network optimization perspective. The relations between FPC parameters and network KPIs (Key Performance Indicators) are investigated. Rather than considering any single KPI in conventional approaches, multi-KPI optimization problem is formulated and solved. By relaxing the discrete optimization problem to a continuous one, the gradients of multiple KPIs with respect to FPC parameters are derived. The gradient enables efficiently searching for optimized FPC parameters which is particularly desirable for dense deployment of large number of cells. Simulation results show that the proposed scheme greatly outperforms the traditional one, in terms of network mean load, call drop & block ratio, and convergence speed.
The paper presents a joint optimization algorithm for coverage and capacity in heterogeneous cellular networks. A joint optimization objective related to capacity loss considering both coverage hole and overlap area based on power density distribution is proposed. The optimization object is a NP problem due to that the adjusting parameters are mixed with discrete and continuous, so the bacterial foraging (BF) algorithm is improved based on network performance analysis result to find a more effective direction than randomly selected. The results of simulation show that the optimization object is feasible gains a better effect than traditional method.
Quadrature compressive sampling (QuadCS) is a newly introduced sub-Nyquist sampling for acquiring inphase and quadrature components of radio-frequency signals. This paper develops a target detection scheme of pulsed-type radars in the presence of digital radio frequency memory (DRFM) repeat jammers with the radar echoes sampled by the QuadCS system. For diversifying pulses, the proposed scheme first separates the target echoes from the DRFM repeat jammers using CS recovery algorithms, and then removes the jammers to perform the target detection. Because of the separation processing, the jammer leakage through range sidelobe variation of the classical match-filter processing will not appear. Simulation results confirm our findings. The proposed scheme with the data at one eighth the Nyquist rate outperforms the classic processing with Nyquist samples in the presence of DRFM repeat jammers.
The ultrafast active cavitation imaging (UACI) based on plane wave can be implemented with high frame rate, in which adaptive beamforming technique was introduced to enhance resolutions and signal-to-noise ratio (SNR) of images. However, regular adaptive beamforming continuously updates the spatial filter for each sample point, which requires a huge amount of calculation, especially in the case of a high sampling rate, and, moreover, 3D imaging. In order to achieve UACI rapidly with satisfactory resolution and SNR, this paper proposed an adaptive beamforming on the basis of compressive sensing (CS), which can retain the quality of adaptive beamforming but reduce the calculating amount substantially. The results of simulations and experiments showed that comparing with regular adaptive beamforming, this new method successfully achieved about eightfold in time consuming.
In distributed wireless storage systems, failed recovery probability depends on not only wireless channel conditions but also storage size of each distributed storage node. For efficient utilization of limited storage capacity, we asymptotically analyze the failed recovery probability of a distributed wireless storage system with a sum storage capacity constraint when signal-to-noise ratio goes to infinity, and find the optimal storage allocation strategy across distributed storage nodes in terms of the asymptotic failed recovery probability. It is also shown that when the number of storage nodes is sufficiently large the storage size required at each node is not so large for high exponential order of the failed recovery probability.
A novel physical layer authentication scheme is proposed in this paper by exploiting the time-varying carrier frequency offset (CFO) associated with each pair of wireless communications devices. In realistic scenarios, radio frequency oscillators in each transmitter-and-receiver pair always present device-dependent biases to the nominal oscillating frequency. The combination of these biases and mobility-induced Doppler shift, characterized as a time-varying CFO, can be used as a radiometric signature for wireless device authentication. In the proposed authentication scheme, the variable CFO values at different communication times are first estimated. Kalman filtering is then employed to predict the current value by tracking the past CFO variation, which is modeled as an autoregressive random process. To achieve the proposed authentication, the current CFO estimate is compared with the Kalman predicted CFO using hypothesis testing to determine whether the signal has followed a consistent CFO pattern. An adaptive CFO variation threshold is derived for device discrimination according to the signal-to-noise ratio and the Kalman prediction error. In addition, a software-defined radio (SDR) based prototype platform has been developed to validate the feasibility of using CFO for authentication. Simulation results further confirm the effectiveness of the proposed scheme in multipath fading channels.
In view of the difficulty in selecting wavelet base and decomposition level for wavelet-based de-noising method, this paper proposes an adaptive de-noising method based on Ensemble Empirical Mode Decomposition (EEMD). The autocorrelation, cross-correlation method is used to adaptively find the signal-to-noise boundary layer of the EEMD in this method. Then the noise dominant layer is filtered directly and the signal dominant layer is threshold de-noised. Finally, the de-noising signal is reconstructed by each layer component which is de-noised. This method solves the problem of mode mixing in Empirical Mode Decomposition (EMD) by using EEMD and combines the advantage of wavelet threshold. In this paper, we focus on the analysis and verification of the correctness of the adaptive determination of the noise dominant layer. The simulation experiment results prove that this de-noising method is efficient and has good adaptability.
In multicarrier direct modulation direct detection systems, interaction between laser chirp and fiber group velocity dispersion induces subcarrier-to-subcarrier intermixing interferences (SSII) after detection. Such SSII become a major impairment in orthogonal frequency division multiplexing-based access systems, where a high modulation index, leading to large chirp, is required to maximize the system power budget. In this letter, we present and experimentally verify an analytical formulation to predict the level of signal and SSII and estimate the signal to noise ratio of each subcarrier, enabling improved bit-and-power loading and subcarrier attribution. The reported model is compact, and only requires the knowledge of basic link characteristics and laser parameters that can easily be measured.
The Philips audio fingerprint[1] has been used for years, but its robustness against external noise has not been studied accurately. This paper shows the Philips fingerprint is noise resistant, and is capable of recognizing music that is corrupted by noise at a -4 to -7 dB signal to noise ratio. In addition, the drawbacks of the Philips fingerprint are addressed by utilizing a “Power Mask” in conjunction with the Philips fingerprint during the matching process. This Power Mask is a weight matrix given to the fingerprint bits, which allows mismatched bits to be penalized according to their relevance in the fingerprint. The effectiveness of the proposed fingerprint was evaluated by experiments using a database of 1030 songs and 1184 query files that were heavily corrupted by two types of noise at varying levels. Our experiments show the proposed method has significantly improved the noise resistance of the standard Philips fingerprint.
Future wireless communications are made up of different wireless technologies. In such a scenario, cognitive and cooperative principles create a promising framework for the interaction of these systems. The opportunistic behavior of cognitive radio (CR) provides an efficient use of radio spectrum and makes wireless network setup easier. However more and more frequently, CR features are exploited by malicious attacks, e.g., denial-of-service (DoS). This paper introduces active radio frequency fingerprinting (RFF) with double application scenario. CRs could encapsulate common-control-channel (CCC) information in an existing channel using active RFF and avoiding any additional or dedicated link. On the other hand, a node inside a network could use the same technique to exchange a public key during the setup of secure communication. Results indicate how the active RFF aims to a valuable technique for cognitive radio manager (CRM) framework facilitating data exchange between CRs without any dedicated channel or additional radio resource.
Wireless channel reciprocity can be successfully exploited as a common source of randomness for the generation of a secret key by two legitimate users willing to achieve confidential communications over a public channel. This paper presents an analytical framework to investigate the theoretical limits of secret-key generation when wireless multi-dimensional Gaussian channels are used as source of randomness. The intrinsic secrecy content of wide-sense stationary wireless channels in frequency, time and spatial domains is derived through asymptotic analysis as the number of observations in a given domain tends to infinity. Some significant case studies are presented where single and multiple antenna eavesdroppers are considered. In the numerical results, the role of signal-to-noise ratio, spatial correlation, frequency and time selectivity is investigated.